MOSCHIP MCS7830 LINUX DRIVER

AXB IDs and manufacturer info obtained from lsusb. NB – these were captured using 2. Thanks again for the info. Right, this method can be used if your target has a USB device port. TP1-TP2 voltage measured solid at 4. You should be able to use it in recent distros. It works perfectly in 2.

Uploader: Malalabar
Date Added: 4 June 2009
File Size: 9.69 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 99992
Price: Free* [*Free Regsitration Required]

Have you tried ifconfig -a? References v t e. Raspberry Pi moschi; when you plug it into the USB port, but after that works fine. Introduction to Linux – A Hands on Guide This guide was created as an overview of the Linux Operating System, geared toward new users as an exploration tour and getting started guide, with exercises at the end of each chapter.

Cable Matters USB 3. Leave a Reply Cancel reply Comment Nickname. New USB device strings: This page was last edited on 6 Julyat My colleague Thomas and I started looking for such devices that would be supported by Linux. While it is advertised as USB 2.

  LINKSY LNE100TX V4.1 DRIVER

CONFIG_USB_NET_MCS7830: MosChip MCS7830 based Ethernet adapters

Works without a powered hub or when plugged into an unpowered hub on a Model “A” Pi. It works perfectly in 2.

Apple USB is OK but like most of the products it looks pretty but is 3 or 4 times the price of other similar devices! Works with a Model “A” Pi if plugged into an external maybe unpowered hub. I can run them again under if it will help. With that driver moachip device is detected, but it does not seem to be possible to actually put any traffic through it.

Unlike later, USB 1. Are you new to LinuxQuestions.

Support for this device at least the references I mentioned was added to Linux 2. Adapter needs last raspbian kernel. Here are a few that we found: You are not directly subscribed to this bug’s notifications.

MCS – ASIX Electronics Corporation

I am not new but just not a guru by a long way. I had it plugged into a powered hub so I cannot say if it works connected directly to the pi. The time now is In a training environment, you are also likely to run out of Ethernet outlets in the training room if you have to connect 8 such boards. Does not work without powered USB hub.

  HANVON DRAWING TABLET MODEL ET0504U DRIVER DOWNLOAD

MCS – USB to 10/M Fast Ethernet Controller | ASIX

If you need to reset your password, click here. This adapter works, but it probably requires a bit of work. Supported by the same driver, but still bulk August update: All except the first use the asix kernel module; the Digitus DN uses the mcs driver.

AXB IDs and manufacturer info obtained from lsusb. Built-in USB Ethernet adapter vs.

This change has been made by an automated script, maintained by the Ubuntu Kernel Team. This bug affects 1 person. Thanks for this informative article.