If you are running a Windows OS, these items are automatically updated whenever you make changes to the Windows Date and Time Properties utility. Installing A Floppy Diskette Drive 5. Never try to install software from a folder that is not specified for use with your mainboard. The clock speed and system bus are deter- mined by the kind of processor you have installed in your system. MSC Folder You can use the software in the following sub-folders:

Uploader: Kerisar
Date Added: 13 December 2008
File Size: 10.11 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 64473
Price: Free* [*Free Regsitration Required]

Page 35 the modem to plug into the mainboard WOM1 connector. The software for this mainboard is stored in the MSC folder. Please supply the information for the items above.

Matsonic MSC Manuals

Turn the system on. The memory bus can run at MHz or MHz. Refer to your drive’s documentation or look on the drive casing if you need to obtain this information.

This publication, including all photographs, illustrations and software. Checking Jumper Matsonci Checking Jumper Settings The following illustration shows the location of the mainboard jumpers. When your system is in a power-saving mode, any modem signal auto- matically resumes the system.


Disable 3-pin BIOS protec- Never try to install software from a folder that is not specified for use with your mainboard.

Other product names used in this manual are the properties of their. Ensure that the edge connector is cor- rectly seated in the slot.

When enabled, separate memory banks are set for odd and even addresses and the next byte of memory can be accessed while the cur- rent byte is being motherboafd. Table of Contents Add to my manuals Add. If you install a primary and secondary add-in IDE interface, set this field to Disabled if the interface does not support prefetching. You must install at least one module in any of the four slots.

MATSONIC MS8137C Manuals

T applet, warns the user of the im- pending condition and advises appropriate action to protect the data. When you first start up your system, go immediately to the Setup Utility to configure the floppy diskette drives that you have installed. Connecting Case Components After you have installed the mainboard into a case, you can begin connecting the mainboard components. If no device is installed, change the value to None. Ms817c features on the mainboard are implemented by cabling connectors on the mainboard to indicators and switches on the system case.


However, we recommend that you read this chapter in case you need to make any changes in the future.

Go to page 1 Chapter 2 Describes installation of main- board components. Pin 1 is labeled. Follow these in- structions: Not finding what you are looking for? The information in this document is subject to change without notice.

Matsonic Msc Socket Motherboard Complete With I/o Plate G/card & CPU | eBay

My database does not. Page 45 Refer to your drive’s documentation or look on the drive casing if you need to obtain ns8137c information. The manufacturer reserves the right to revise this publication and to.

Disable this item if your graphics display card does not support this feature. Jumper 4 — Use this jumper to select the CPU frequency. The memory that your motherboard can take is DDR Don’t show me this message again. Answer questions, earn points and help others Answer questions.