ARGOX X-3200 PPLB DRIVER

When the left side of the label exhibits inferior printing quality, as shown in Fig. Loose the screws at both sides and rotate counter-clockwise: Enter Printer name i. The printer feeds inches of blank labels. Figure 3 3 Dispenser Module Peel Lever 25 4.

Uploader: Fauzilkree
Date Added: 24 August 2011
File Size: 50.75 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 37886
Price: Free* [*Free Regsitration Required]

ARGOX X-3200

Press and hold the FEED button while turning on the power. The following describes how to solve ribbon wrinkle accordingly. Advanced Installation and Adjustment This chapter describes installation and adjustment procedure for X series industrial printers.

For technical and pin-out information, please refer to the Technical Reference in this manual. You must perform the calibration after resetting the printer.

Then install the ribbon: The screens included for these steps are taken from Windows XP; steps in other versions of operation systems are similar. The language selection screen appears. If the ribbon is wrinkled at ribbon pickup, rotate counter-clockwise control knob of ribbon pickup, to decrease ribbon tension at ribbon pickup and further improve ribbon wrinkle. Even though the “Add Printer Wizard” is from Microsoft, it too easily performs a number of tasks incorrectly when updating existing drivers.

  HEWLETT PACKARD DESKJET 640C PRINTER DRIVER DOWNLOAD

On the contrary, DHCP setting is enabled. Ribbon roll — Max. Figure 3 3 Ribbon Supply Spindle 14 4. Turn the head latch counter-clockwise and open the bracket.

A label is printed. After changing sensor setting, make sure to calibrate before printing. Hold both buttons for about 3 seconds and release. Loose the three screws from Tear-off Bracket and then remove Tear Bracket. Off — direct thermal mode with no ribbon installed.

Figure 2 13 2 Head Latch Bracket 3. Figure 1 1 Backing Paper 24 2. Load new media to the printer. Clockwise rotate the screw a half circle p;lb test printing; observe whether the printing quality has been gradually improved or not; and stop the adjustment if the quality is improved.

Argox X |

Figure 2 2 Print Head Module 3. Centronics allows a much higher communication speed than serial. Turn off the printer; disconnect the AC power cable. Select the port of the printer and click “Next”.

For example, the first option of print modes is thermal transfer. Delete by application software for those no longer in use. Printer finds the first label gap when print head is closed.

  COMPAQ V3010 WIRELESS DRIVER DOWNLOAD

The heavy duty is capable of 5ips print speed using its bit RISC microprocessor. Printer Operation The illustrations below describe parts and features of X-Series. The CD-Rom will bring out the following prompt. Figure A Figure B Once the printouts as above appear, the possible cause may be the unequal positions of Ribbon Bracket, which needs to be adjusted properly to make its heights equally the same at both sides.

Connect the barcode reader to the keyboard interface.

Make a form for the keyboard. Printer performs Auto Calibration after printing the first label, if label height differs from parameters in printer’s flash.